1st Model	2nd Model	Marine Corps

New reproductions of the "pup tents" used by American troops during WWII. Choose 1st Pattern (one end closes) or 2nd Pattern (can be closed at both ends), or Marine camouflage shelter halves.

This is a complete tent, and includes:
2 x shelter halves

Hardware sets may be added at extra cost:
2 x folding tent poles
10 x tent pegs
Rope set (2 x guy lines, 10 x peg ropes)

All items are now imported except the tent pegs which are made in PA.

When fully assembled, tents are approximately 9ft long and 43" tall.

Imported.

Getting the peg ropes though the grommets:

I found this to be a real S.O.B. of a job at first. After couple minutes of consternation, I double checked our rope and grommet sizes against the originals to be sure we hadn't measured incorrectly as it appears there is no way these will fit- but they do. Following more head scratching, I had a Macgyver moment and found a solution:

I'm not sure if this is the "1942 approved" method, but it works well. Use a standard G.I. shoe lace, feed it through from what you want to be the outside of the grommet (right and left halves will need to be threaded opposite from one another), loop the rope through it, and use the shoe lace to pull the rope through. You will still need to compress the rope at the tip as much as possible with your fingers, but this works far better than fingers alone. Once the rope is through the grommet, then knot each end to prevent it from slipping out or fraying.

Feed shoe lace through the grommet from the "outside"	Compress the end as much as possible to start it through	Pull through	Knot the ends